Standard ping works this way - packet goes out the interface closest to the
destination. The source address is that interface. The router doesn't like
this.
Try an extended ping using as the source a different address. IP routing
should be on, but the two interfaces need not be in a routing process.
Chuck
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of
[EMAIL PROTECTED]
Sent: Monday, May 07, 2001 3:49 PM
To: [EMAIL PROTECTED]
Subject: cannot ping myself [7:3498]
#sh run
...
!
interface Serial1
description Enlace al San Alfonso (BellSouth)
ip address 10.10.10.1 255.255.255.0
no ip directed-broadcast
encapsulation frame-relay IETF
no fair-queue
frame-relay interface-dlci 16
frame-relay lmi-type ansi
!
...
#ping 10.10.10.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.10.10.1, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
(pinging 10.10.10.1 from other box works, but by the own router doesn't)
What can be happening?
Thanks,
HoraPe
---
Horacio J. Peqa
[EMAIL PROTECTED]
[EMAIL PROTECTED]
[EMAIL PROTECTED]
[EMAIL PROTECTED]
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=3500&t=3498
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
