I mentioned this in passing a few days ago.
If your router(s) have a cybus then the command:
show controllers cbus utilization
will let you know how hard those cybus' are working
Router7513>sh cont cbus util
CY0Bus utilization for five seconds: 8%; one minute: 8%; five minutes: 8%
CY1Bus utilization for five seconds: 13%; one minute: 13%; five minutes: 13%
You would use this to help you load balance the buses.
Kevin Wigle
----- Original Message -----
From: "Watson, Rick, CTR, OUSDC"
To:
Sent: Thursday, 14 June, 2001 11:09
Subject: 'show controllers' command [7:8528]
> ...reading the Cisco Press Support Book. They talked about the 'show
> controllers' command. My question is when and why would you use this
> command? I read that the output can be overwhelming, and that some of the
> information is irrelevant! Go figure!. But again, when would you need the
> information form this command? Thanks for the insight.
>
> Rick Watson
> Network Engineer
> Advanced Systems Development, Inc.
> OUSD(Comptroller)
> 703.697.5710 office
> [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8652&t=8528
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
