I have two 1602 routers on each side. They each of a T1 WIC card that is
also the DSU...
Do I need to set a clock rate on one side? I didn't think so, but maybe I
was wrong.
Thanks again,
-----Original Message-----
From: Brian Whalen [mailto:[EMAIL PROTECTED]]
Sent: Monday, August 27, 2001 4:36 PM
To: Marshal Schoener
Cc: [EMAIL PROTECTED]
Subject: Re: point-to-point question? [7:17437]
Perhaps they're talking about clocking. If you have control over csus on
both sides, typically one would be a timing source, and the other would be
set to external timing.
Brian "Sonic" Whalen
Success = Preparation + Opportunity
On Mon, 27 Aug 2001, Marshal Schoener wrote:
> Hey all,
>
> I was told that on a point-to-point dedicated T1, one router needs to be
> setup as a master, and the other router
> needs to be setup as a slave...
> Is there any truth to this, and if so, how would I go about doing it?
>
> I have never heard of anything like this before.
>
> Again, it isn't frame-relay, it's just a dedicated point-to-point link.
>
> Thanks a million in advance,
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=17442&t=17437
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
