Thanks,
It's a full T1. There was never a problem until there was a power outage.
Ever since then, there have been strange problems trying to hit the remote
servers from the offices...
The setup is simple, being that it is HDLC and only really requires an IP
address on the interface and some routes :)
But, Im thinking that there can be a problem on one of the WICs...
Thanks again,
-----Original Message-----
From: Brian Whalen [mailto:[EMAIL PROTECTED]]
Sent: Monday, August 27, 2001 4:55 PM
To: Marshal Schoener
Cc: [EMAIL PROTECTED]
Subject: RE: point-to-point question? [7:17437]
clock rate is a different deal. Is this a full or fractional t1? if its
full t1, I suspect the card will support that rate properly. If its
fractional, then your intervention will be required to set the number of
timeslots properly.
Brian "Sonic" Whalen
Success = Preparation + Opportunity
On Mon, 27 Aug 2001, Marshal Schoener wrote:
> I have two 1602 routers on each side. They each of a T1 WIC card that is
> also the DSU...
> Do I need to set a clock rate on one side? I didn't think so, but maybe I
> was wrong.
>
>
> Thanks again,
>
> -----Original Message-----
> From: Brian Whalen [mailto:[EMAIL PROTECTED]]
> Sent: Monday, August 27, 2001 4:36 PM
> To: Marshal Schoener
> Cc: [EMAIL PROTECTED]
> Subject: Re: point-to-point question? [7:17437]
>
>
> Perhaps they're talking about clocking. If you have control over csus on
> both sides, typically one would be a timing source, and the other would be
> set to external timing.
>
> Brian "Sonic" Whalen
> Success = Preparation + Opportunity
>
>
> On Mon, 27 Aug 2001, Marshal Schoener wrote:
>
> > Hey all,
> >
> > I was told that on a point-to-point dedicated T1, one router needs to be
> > setup as a master, and the other router
> > needs to be setup as a slave...
> > Is there any truth to this, and if so, how would I go about doing it?
> >
> > I have never heard of anything like this before.
> >
> > Again, it isn't frame-relay, it's just a dedicated point-to-point link.
> >
> > Thanks a million in advance,
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=17450&t=17437
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
