Easy IP is just nat over a negoiated address. You make it work by calling
out the interface, instead of a nat pool in your nat statment. Simple. It
works on ISDN via PPP address asignment or ethernet via DHCP or BOOTP or
even PPPoE. The example that I showed him is for ISDN.
Tony
----- Original Message -----
From: "Leigh Anne Chisholm"
To: "Tony Medeiros" ; ; "Bob
Lepine"
Sent: Saturday, September 08, 2001 2:45 PM
Subject: RE: Cable Modem, DHCP & NAT [7:19106]
> TONY: If I remember correctly, when I was trying to research this
> configuration using a single Ethernet interface, Easy IP is just for BRI
> ISDN. I'm not quite sure that Easy IP was what Bob was looking for. The
> sample NAT config included in that example though would apply if you
applied
> the NAT config of the BRI to the Ethernet interface Bob's using to
negotiate
> the IP address.
>
>
> BOB: Are you trying to do this using a single Ethernet interface, or two
> Ethernet interfaces?
>
>
> -- Leigh Anne
>
> > -----Original Message-----
> > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
> > Tony Medeiros
> > Sent: Saturday, September 08, 2001 10:41 AM
> > To: [EMAIL PROTECTED]
> > Subject: Re: Cable Modem, DHCP & NAT [7:19106]
> >
> >
> > Here you go. It's called "easy IP". It's just NAT over a negotiated
> > interface.
> > http://www.cisco.com/warp/customer/793/access_dial/easyip.html
> >
> > Tony M
> > #6172
> >
> > ----- Original Message -----
> > From: "Bob Lepine"
> > To:
> > Sent: Saturday, September 08, 2001 5:44 AM
> > Subject: Cable Modem, DHCP & NAT [7:19106]
> >
> >
> > > Hi, I have a 2600 router and the latest software so I can get a DHCP
> > number
> > > from my service provider. I'm trying to configure the router so
> > that I can
> > > put my static network on the inside. It accepts the DHCP number but I
> > can't
> > > get it to do the translation to the inside seeing that the
> > outside number
> > is
> > > not a static number. Anyone have experience with this?
> > > Any help would be appreciated.
> > >
> > >
> > > --
> > > Bob Lepine
> > > MCSE,MCDBA,CNA,CCNA,MCT
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=19141&t=19106
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
