Hello, A couple of weeks back someone had successfully configured his 2514 router to get a dhcp ip addr. from his cable service provider, configured nat on the router for his laptop to go out on the internet. I tried to do the same on my 2514 but I cannot type the command under e0 for my router to get the dhcp ip addr. from the service provider. I initially thought that it was the ios ver. (was using 11.3.(3)) I upgraded to 12.0.(9) but it still will not let me type the command. Will this command only work on higher routers like the 2600 and the 3600 series. Please advise. Thank you. Kind regards.
Output from the router: RTA(config-if)#ip dhcp ? % Unrecognized command RTA#conf t Enter configuration commands, one per line. End with CNTL/Z. RTA(config)#int e0 RTA(config-if)#ip ? Interface IP configuration subcommands: access-group Specify access control for packets accounting Enable IP accounting on this interface address Set the IP address of an interface authentication authentication subcommands bandwidth-percent Set EIGRP bandwidth limit broadcast-address Set the broadcast address of an interface cgmp Enable/disable CGMP directed-broadcast Enable forwarding of directed broadcasts dvmrp DVMRP interface commands hello-interval Configures IP-EIGRP hello interval _________________________________________________________________ Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=22250&t=22250 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]