"ip address negotiate"... > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of > Cisco Nuts > Sent: Friday, October 05, 2001 1:01 PM > To: [EMAIL PROTECTED] > Subject: ip dhcp-server under e0?? [7:22250] > > > Hello, > A couple of weeks back someone had successfully configured his > 2514 router > to get a dhcp ip addr. from his cable service provider, configured nat on > the router for his laptop to go out on the internet. I tried to > do the same > on my 2514 but I cannot type the command under e0 for my router > to get the > dhcp ip addr. from the service provider. I initially thought that > it was the > ios ver. (was using 11.3.(3)) I upgraded to 12.0.(9) but it still > will not > let me type the command. Will this command only work on higher > routers like > the 2600 and the 3600 series. Please advise. > Thank you. > Kind regards. > > Output from the router: > > RTA(config-if)#ip dhcp ? > % Unrecognized command > > > RTA#conf t > Enter configuration commands, one per line. End with CNTL/Z. > RTA(config)#int e0 > RTA(config-if)#ip ? > Interface IP configuration subcommands: > access-group Specify access control for packets > accounting Enable IP accounting on this interface > address Set the IP address of an interface > authentication authentication subcommands > bandwidth-percent Set EIGRP bandwidth limit > broadcast-address Set the broadcast address of an interface > cgmp Enable/disable CGMP > directed-broadcast Enable forwarding of directed broadcasts > dvmrp DVMRP interface commands > hello-interval Configures IP-EIGRP hello interval > > > > > _________________________________________________________________ > Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=22255&t=22250 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]