Configure bridge groups on the switch, and assign ports to the bridge groups as required.
CM ----- Original Message ----- From: " 416South" To: Sent: Thursday, January 17, 2002 9:03 PM Subject: VLAN's [7:32351] > Have a 2948GL 3 and want to set up a vlan but it docs state that you have to > set up ISL . I don't want ISL enabled. is there a way to just create VLANS > like in other L3 switches? I don't want to make these routeable or anything > just L2 VLANS simple VLANS > > ie. when I do a "int vlan 400" this would normally create a new vlan and put > me into interface mode > > when i do a "int vlan ?" the options are to put in the vlan # but when I do > all i get is a wrong command with the famous ^ at the vlan point in the > command > > docs doc's dont seem to give enough info > > any Ideas???? > > thanks Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=32361&t=32351 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]