Hi Sam, Here is the configuration and the output of the show commands, please note the first router is showing it's joining to the multicast group 224.0.0.2 while the other not !
R1 interface FastEthernet1/0 ip address 172.16.0.2 255.255.0.0 ip broadcast-address 0.0.0.0 no ip redirects standby 10 ip 172.16.0.37 R2 ip address 172.16.0.36 255.255.0.0 ip directed-broadcast duplex auto speed auto standby 10 ip 172.16.0.37 R1#show ip interface fastEthernet 1/0 FastEthernet1/0 is up, line protocol is up Internet address is 172.16.0.2/16 Broadcast address is 0.0.0.0 Address determined by non-volatile memory MTU is 1500 bytes Helper address is not set Directed broadcast forwarding is enabled Multicast reserved groups joined: 224.0.0.10 224.0.0.2 Outgoing access list is not set Inbound access list is not set Proxy ARP is enabled Security level is default Split horizon is enabled ICMP redirects are never sent ICMP unreachables are always sent ICMP mask replies are never sent IP fast switching is enabled IP fast switching on the same interface is disabled IP multicast fast switching is enabled Router Discovery is disabled IP output packet accounting is disabled IP access violation accounting is disabled TCP/IP header compression is disabled RTP/IP header compression is disabled Probe proxy name replies are disabled Gateway Discovery is disabled Policy routing is disabled Network address translation is disabled R2#show ip interface fastEthernet 0/0 FastEthernet0/0 is up, line protocol is up Internet address is 172.16.0.36/16 Broadcast address is 255.255.255.255 Address determined by setup command MTU is 1500 bytes Helper address is not set Directed broadcast forwarding is enabled Outgoing access list is not set Inbound access list is not set Proxy ARP is enabled Security level is default Split horizon is enabled ICMP redirects are always sent ICMP unreachables are always sent ICMP mask replies are never sent IP fast switching is enabled IP fast switching on the same interface is disabled IP Flow switching is disabled IP Feature Fast switching turbo vector IP multicast fast switching is enabled IP multicast distributed fast switching is disabled IP route-cache flags are Fast Router Discovery is disabled IP output packet accounting is disabled IP access violation accounting is disabled TCP/IP header compression is disabled RTP/IP header compression is disabled Probe proxy name replies are disabled Policy routing is disabled Network address translation is disabled WCCP Redirect outbound is disabled WCCP Redirect exclude is disabled BGP Policy Mapping is disabled ""Sam Sneed"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Could you post your config's for those 2 routers and possibly sh int output? > > > ""Mohannad Khuffash"" wrote in message > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > > Hi ... > > > > I have tried to configure HSRP on two 3660 routers, I configured them > > straight forward where only a little commands needed.But HSRP don't worked > > well ! The reason simply was that they are not seeing the HSRP hello > > messages so every one act as the active one ! When I checked the problem > > more, I discovered that both of them are not seeing the 224.0.0.2 messages > > by using the SHOW IP INTERFACE command where none of the interfaces of the > > two routers are joined for this multicast group ! > > My question now is how I can make them joined to 224.0.0.2 which should be > > the default configuration ? Or may be I'm wrong in my investigation ?! > > > > Thanks for your help > > > > -- > > > > > > > > > > > > > > > > Mohannad Khuffash Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=59627&t=59609 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
