Hi Dave, Thanx for the reply,but I am still not clear > Sounds about right. In the Lucent 9000 frame realy switch doc, > this > is a carrier class switch, it list the range of 16-001 as > available for > all LMI types and 16-1007 for LMI Rev1 which is the same a > Cisco LMI. > 1-15 and 1008-1023 are reserved. > > Dave > > Simmi Singla wrote: > > Hi all, > > I have read in one of the books and internet also that dlci > value range is > > dependent on lmi type configured. > > Example > > The following DLCI ranges are based on LMI protocol: > > > > ANSI: 16 - 991 > > > > CISCO: 16 - 1007 > > > > Q933a: 16 - 991 > > > > But when we configure LMI type as example take ansi so after > this when we > > confgure dlci value ut still shows the dlci range of 16-1007 > > why is it so .it should show range of this in cisco router > 16-991 > > any comments on above problems > > Thanx in advance > -- > David Madland > CCIE# 2016 > Sr. Network Engineer > Qwest Communications > 612-664-3367 > > "You don't make the poor richer by making the rich poorer." > --Winston > Churchill > >
Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=61641&t=61608 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]