I meant the first range to read 16-1007, need to proof read before sending:(
Dave Simmi Singla wrote: > Hi Dave, > Thanx for the reply,but I am still not clear > >>Sounds about right. In the Lucent 9000 frame realy switch doc, >>this >>is a carrier class switch, it list the range of 16-001 as >>available for >>all LMI types and 16-1007 for LMI Rev1 which is the same a >>Cisco LMI. >>1-15 and 1008-1023 are reserved. >> >> Dave >> >>Simmi Singla wrote: >> >>>Hi all, >>>I have read in one of the books and internet also that dlci >> >>value range is >> >>>dependent on lmi type configured. >>>Example >>>The following DLCI ranges are based on LMI protocol: >>> >>>ANSI: 16 - 991 >>> >>>CISCO: 16 - 1007 >>> >>>Q933a: 16 - 991 >>> >>>But when we configure LMI type as example take ansi so after >> >>this when we >> >>>confgure dlci value ut still shows the dlci range of 16-1007 >>>why is it so .it should show range of this in cisco router >> >>16-991 >> >>>any comments on above problems >>>Thanx in advance >> >>-- >>David Madland >>CCIE# 2016 >>Sr. Network Engineer >>Qwest Communications >>612-664-3367 >> >>"You don't make the poor richer by making the rich poorer." >>--Winston >>Churchill -- David Madland CCIE# 2016 Sr. Network Engineer Qwest Communications 612-664-3367 "You don't make the poor richer by making the rich poorer." --Winston Churchill Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=61665&t=61608 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]