enter the no shut command into your cut and paste script for the Int Ser0 and it will come up..all interfaces in a router are always defaulted to shutdown..In your case the Main interface needs to be no shut in order for the logical interface to work...
-- Larry Letterman Network Engineer Cisco Systems ""Monu Sekhon"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Hi All > Hey I am facing a strange problem in frame-relay > > My config > ---------- > my initial config > int serial 0 > (nothing confgured initially) > > Then I cut paste this config and my link does not come up means Interface > does not come up. > > interface Serial0 > shut (if i give here no shut then link comes up at one go) > encapsulation frame-relay > frame-relay lmi-type cisco > exit > interface Serial0/0.1 point-to-point > no shutdown > ip address 1.1.1.1 255.255.255.0 > frame-relay interface-dlci 108 > exit > > I have to do shut and no shut on main interface why ? > > if the above commands i execute one by one then the link comes up. > > Is it a differnece between pasting the config at one go or what when i give > command single by single. > I enable debugging for frame-relay packets and it shows encap faiiled once > only on the above sub interface.is anything frame-relay lmis has anything > to do. > I am very confused. > Thanx in advance [EMAIL PROTECTED] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=63454&t=63446 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]