My 27 Mk III has Barient 18 primary and Barient 10 halyard winches. I too have been pondering replacements.
From: sam.c.sal...@gmail.com Sent: Monday, August 05, 2013 5:59 PM To: cnc-list@cnc-list.com Subject: Re: Stus-List Primary winches for MkII 27' Whatever you decide to buy, self tailers are the next best investment after new sails! sam :-) 403-617-6280 From: Paul Baker Sent: Monday, August 5, 2013 6:55 PM To: cnc-list@cnc-list.com Reply To: cnc-list@cnc-list.com Subject: Re: Stus-List Primary winches for MkII 27' Sam - You're lucky to have a foresail trimmer, my foresail trimmer is the same guy that is doing the main sail trim, and the helming, and operating the engine, and hoisting the sails, and getting the boat to and from the dock, i.e. me. I don't have an autohelm, nor even a wheel brake, so something easy to operate is my primary need as I almost exclusively single-hand (quite literally). Rick - it sounds like you've sailed some nicely over-winched boats, my 24' had Barient 12s if I recall correctly, and they were fine on a boat that size. Steve - they must have put bigger winches on later boats, I checked today and they are definitely 16s on there. I might pull the trigger on a pair of shiny stainless Andersons if they physically fit, I have to get the measurements. It's only money *sigh*. Cheers, Paul. On 13-08-05 04:46 PM, sam.c.sal...@gmail.com wrote: Not quite the same size, but my 26 has had Lewmar 16ST's on the combing for about 4 seasons now. I sail with a 135 on a roller furler. Sheets are Yale PhD. ā€ˇWorks perfectly according to my foresail trimmer.Definitely don't need a 2 speed unless you're not very good at tacking. SamC&C 26 Liquorice Ghost Lake Alberta From: Paul Baker Sent: Monday, August 5, 2013 3:03 PM To: cnc-list@cnc-list.com Reply To: cnc-list@cnc-list.com Subject: Stus-List Primary winches for MkII 27' Hi Listers, I'm seriously considering replacing the current (I assume factory standard) Barient single-speed winches. I'm not at the boat at the moment, I think they are 16s. Anyway, I am looking at the Anderson 28ST (two speed, self tailers). Is the 28 too big, too small, what do you have on your 27? Cheers, Paul. Orange Crush 1974 27MkII _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com -------------------------------------------------------------------------------- _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com -------------------------------------------------------------------------------- _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com