Tom - I did something similar, but made it out of prefab fiberglass from
McMaster-Carr. I used little fiberglass blocks epoxied to the hull.
This was an early project (14 years ago... yikes!) and I'd do it better
now. However, I can replace the little bilge pump without pulling
everything out, since it's hose clamped to the bracket. That's turned
out to be a good idea.
<http://www.wbryant.com/StellaBoat/Projects/bilgepmp/bilgepmp.htm>
Wal
Tom wrote:
I am planning on mounting my new auto bilge switch to a plate then lower the
plate into the bilge and mounting it to the side of the bilge. Much easier
than trying to mount to the bottom of the bilge.
My question is if I use an aluminum plate and mount it with stainless
fasteners, will I have any corrosion issues?
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com