That hose should just be replaced by new hose with the smooth sections. When it gets old it starts getting pinhole leaks in various places
Joe Della Barba j...@dellabarba.com <mailto:j...@dellabarba.com> Coquina C&C 35 MK I From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Eric Frank via CnC-List Sent: Monday, April 27, 2015 8:59 AM To: cnc-list@cnc-list.com Subject: Stus-List Connection fittings for corrugated bilge pump hose The 1.5 inch ID corrugated hose that runs from the bilge to a manual pump in the cockpit seems to be leaking in air just where the corrugated hose connects to an adaptor that screws into the hose with the threads of the corrugation and then provides a male 1.5 inch end that fits inside the strainer. Is there a sealer that would make the threaded part into the hose less leaky? I see the new corrugated hoses on line have a built-in non-corrugated section every 12 inches, a much better solution, but then I would have to buy a new 15 ft length of the hose. Probably someone on this list also has dealt with these older style connectors. Any recommendation for making the connection tighter? I just screwed it on until it was tight and it still leaks. The problem is that it takes vigorous pumping from the cockpit to get the entire hose full of water before it pumps very well. Thanks! Eric Frank Cat's Paw C&C 35 Mk II Mattapoisett, MA
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
