Those hoses with the non-corrigated sections are of poorer quality and will not likely last very long. The Shields 141 hose is a reasonable value for bildge hose.
Josh On Apr 27, 2015 8:59 AM, "Eric Frank via CnC-List" <cnc-list@cnc-list.com> wrote: > The 1.5 inch ID corrugated hose that runs from the bilge to a manual pump > in the cockpit seems to be leaking in air just where the corrugated hose > connects to an adaptor that screws into the hose with the threads of the > corrugation and then provides a male 1.5 inch end that fits inside the > strainer. Is there a sealer that would make the threaded part into the > hose less leaky? I see the new corrugated hoses on line have a built-in > non-corrugated section every 12 inches, a much better solution, but then I > would have to buy a new 15 ft length of the hose. Probably someone on this > list also has dealt with these older style connectors. Any recommendation > for making the connection tighter? I just screwed it on until it was tight > and it still leaks. The problem is that it takes vigorous pumping from the > cockpit to get the entire hose full of water before it pumps very well. > Thanks! > > Eric Frank > Cat's Paw > C&C 35 Mk II > Mattapoisett, MA > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com