You have a keyway in the shaft and transmission coupling? Ed
On Wed, May 23, 2018, 3:14 PM ed vanderkruk, <primeinter...@gmail.com> wrote: > When you say coupling bolts ... the bolts mounting the transmission to the > bell housing? > > Anyone check the transmission? > > > Ed > > Prime Interest > 1982 LF38 > Toronto > > On Wed, May 23, 2018, 2:49 PM detroito91 via CnC-List, < > cnc-list@cnc-list.com> wrote: > >> The boat in question is an 81 landfall 38. >> The v-drive coupling bolts have sheared off 3 times and caused loss of >> power. >> Have been very careful to pause when changing gears. >> The westerbeak engine runs great throughout all this. The shaft removed >> and checked after the second time. The 2 bladed max prop sent back and >> rebuilt. New motor mounts installed by po when replacing engine. About 4 >> years ago (<200 hours on engine) coupling. Allignment done each time and >> found okay. >> I am looking for advice, suggestions, similar situations and >> corrections. HELP >> Losing confidence in boat. >> Thanks >> Jim schwartz >> SEA YA I >> 38 LF >> Washington nc >> _______________________________________________ >> >> Thanks everyone for supporting this list with your contributions. Each >> and every one is greatly appreciated. If you want to support the list - >> use PayPal to send contribution -- https://www.paypal.me/stumurray >> >>
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray