On 2014-05-21 06:30, Roman Lebedev wrote: >> Back to the initial question, worded even shorter: "Is it possible to >> manually select a few pictures in the light table mode and batch > enable > >lens correction ? How ?" > > If you are using DT v1.5 (git master only) then you can: > if the values that are set in lens iop after you press reset (or just > switch it on without touching any controls) are fine for you - then > just create auto-appliable preset and everything will work exactly as > you would expect it to work >
But in my case I have to manually choose the lens --- so this will not apply, correct? I have not seen the 1.5 implementation, but my suggestion is that the (subset) of parameters in a module that could be auto-applied (in the case of the exposure, is just one; in the case of the lens correction, there are two or even three sets - lens type, geometry, TCA) should have an "auto" tick; when ticked, the parameters are grayed out and automatically recalculated on paste. It's IMHO clean and intuitive. Thanks! ------------------------------------------------------------------------------ "Accelerate Dev Cycles with Automated Cross-Browser Testing - For FREE Instantly run your Selenium tests across 300+ browser/OS combos. Get unparalleled scalability from the best Selenium testing platform available Simple to use. Nothing to install. Get started now for free." http://p.sf.net/sfu/SauceLabs _______________________________________________ Darktable-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/darktable-users
