Can anyone help me here? I've got an AHA1542 with a quantum XP32150W
as the only device on the chain. I keep getting errors like the following:
scsi : aborting command due to timeout : pid 198, scsi0, channel 0, id 0, lun 0
Write (10) 00 00 27 88 b0 00 00 76 00
scsi : aborting command due to timeout : pid 198, scsi0, channel 0, id 0, lun 0
Write (10) 00 00 27 88 b0 00 00 76 00
SCSI host 0 abort (pid 198) timed out - resetting
SCSI bus is being reset for host 0 channel 0.
Sent BUS DEVICE RESET to target 0
Sending DID_RESET for target 0
Sending DID_RESET for target 0
Sending DID_RESET for target 0
Sending DID_RESET for target 0
aha1542_intr_handle: Unexpected interrupt
tarstat=0, hastat=0 idlun=10 ccb#=5
aha1542_intr_handle: Unexpected interrupt
tarstat=0, hastat=0 idlun=10 ccb#=7
On boot I get this from the kernel:
Aug 18 10:35:55 mattice kernel: Configuring Adaptec (SCSI-ID 7) at IO:334, IRQ
15, DMA priority 5
Aug 18 10:35:55 mattice kernel: scsi0 : Adaptec 1542
Aug 18 10:35:55 mattice kernel: scsi : 1 host.
Aug 18 10:35:55 mattice kernel: Vendor: Quantum Model: XP32150W
Rev: L912
Aug 18 10:35:55 mattice kernel: Type: Direct-Access
ANSI SCSI revision: 02
Aug 18 10:35:55 mattice kernel: Detected scsi disk sda at scsi0, channel 0, id
0, lun 0
Aug 18 10:35:55 mattice kernel: scsi : detected 1 SCSI disk total.
Aug 18 10:35:55 mattice kernel: sda: Spinning up disk............ready
Aug 18 10:35:55 mattice kernel: SCSI device sda: hdwr sector= 512 bytes.
Sectors= 4199760 [2050 MB] [2.1 GB]
Are there any settings I need to tweak in order to rid myself of
these timeout errors?
Mike
