Hi Daniel, At what value is router.aggregation.command.each.timeout global setting?
Can you tell a bit about your setup, what the router does (config) as in how many VMs, tiers, public IPs etc. Regards, Remi Sent from my iPhone > On 28 Jan 2016, at 05:18, Daniel Mezentsev <d...@soleks.com> wrote: > > Hi Remi, > > I just upgraded 4.6.2->4.7.1 The same issue, unable to start 2 VRs (out of > 8 total). VR actually is started, running for 5-7 minutes, then shuting > down. One thing that i noticed in the log: > > arping -c 1 -I eth0 -A -U -s 10.1.12.1 None > > What is "None" here ? > > Please let me know what information from the log can i provide you to help > with troubleshooting. I noticed that there are a lot of the same issues > happened after upgrade to 4.6, seems like it's getting critical. > >> No, just the same template so it's just a matter of upgrading package. >> Will ping you when the release is ready. >> >> Regards, Remi >> >> Sent from my iPhone >> >>> On 25 Jan 2016, at 21:41, Daniel Mezentsev <d...@soleks.com> wrote: >>> >>> Hi Remi, >>> >>> Absolutely. I don't see any issue to do upgrade to 4.7.1. Will it be > with >>> new templates for system VMs ? >>> >>>> Hi Daniel, >>>> >>>> Is upgrading to 4.7.1 (once released tomorrow) an option? It has many >>>> improvements over 4.6.x and I'm quite sure it fixes the problem you >>>> experience now. >>>> >>>> Regards, Remi >>>> >>>> Sent from my iPhone >>>> >>>>> On 25 Jan 2016, at 16:29, Daniel Mezentsev <d...@soleks.com> wrote: >>>>> >>>>> in my configuration VR is acting as DHCP/DNS server, so it's not >>>>> passing >>>>> any traffic, so i can exclude public IP addresses. Definetely there is >>>>> one >>>>> of the VR script is acting badly. >>>>> >>>>>> If I disassociated 10 public IPs and keep 10 public IPs (but keep 20 >>> >>> vms >>>>>> associated with the network), the network (virtual router) restart >>>>>> with >>>>>> clean up successfully (around in 3 min). >>>>>> I thinks that is a timeout problem (or VR scripts performance)... but >>>>>> which timeout parameter? >>>>>> >>>>>>> On 24/01/2016 09:43, Milamber wrote: >>>>>>> Please note, my installation type is Advanced network without >>>>>>> security >>>>>>> groups (vlan isolation). >>>>>>> >>>>>>>> On 24/01/2016 06:57, Remi Bergsma wrote: >>>>>>>> Hi, >>>>>>>> >>>>>>>> We have seen this issue sometimes in the VRs from 4.6 and on. There >>>>>>>> have been several improvements in the code in 4.7. >>>>>>>> >>>>>>>> Also, setting router.aggregation.command.each.timeout global > setting >>>>>>>> to 15 or 20 also may help (restart mgt server after change). >>>>>>>> >>>>>>>> @Milamber can you test this setting with 4.7.1RC please? I haven't >>>>>>>> seen this issue in my test and production systems. >>>>>>>> >>>>>>>> Thanks, Remi >>>>>>>> >>>>>>>> Sent from my iPhone >>>>>>>> >>>>>>>>> On 24 Jan 2016, at 00:49, Milamber <milam...@apache.org> wrote: >>>>>>>>> >>>>>>>>> Hello, >>>>>>>>> >>>>>>>>> I've have a similiar issue without solution (but not with an >>>>>>>>> upgrade >>>>>>>>> from 4.5), please see >>>>>>>>> https://issues.apache.org/jira/browse/CLOUDSTACK-9255 >>>>>>>>> >>>>>>>>> Milamber >>>>>>>>> >>>>>>>>>> On 24/01/2016 03:32, Daniel Mezentsev wrote: >>>>>>>>>> Hi All, >>>>>>>>>> >>>>>>>>>> I've got some issue after i did cloudstack upgrade 4.5 -> 4.6.2. >>>>>>>>>> Environment has 8 VR, 6 were upgraded and restarted >>>>>>>>>> successfully, 2 >>>>>>>>>> of them >>>>>>>>>> stuck. I removed them - the same result, i can't boot them, >>>>>>>>>> restarted >>>>>>>>>> network with clean-up - no luck. >>>>>>>>>> VR actually is starting, i can ssh to it, but it's shuting down > in >>>>>>>>>> approx 5 >>>>>>>>>> minutes. I can extend it runing >>>>>>>>>> "init 3" command, but cloudstack is not detecting router state. >>>>>>>>>> >>>>>>>>>> I can bing some VMs within the same subnet, so it's not >>> >>> VLAN/network >>>>>>>>>> issue. >>>>>>>>>> >>>>>>>>>> Completely ran out of ideas. >>>>>>>>>> Should mention network offering is Isolated network without NAT. >>>>>>>>>> >>>>>>>>>> Any help is more then welcome. I can provide any related log, >>>>>>>>>> but i >>>>>>>>>> need >>>>>>>>>> some heads-up what i should look for. >>>>>>>>>> Daniel Mezentsev, founder >>>>>>>>>> (+1) 604 313 8592. >>>>>>>>>> Soleks Data Group. >>>>>>>>>> Shaping the clouds. >>>>> >>>>> Daniel Mezentsev, founder >>>>> (+1) 604 313 8592. >>>>> Soleks Data Group.Shaping the clouds. >>> >>> Daniel Mezentsev, founder >>> (+1) 604 313 8592. >>> Soleks Data Group.Shaping the clouds. > Daniel Mezentsev, founder > (+1) 604 313 8592. > Soleks Data Group. > Shaping the clouds.
