Nice program, but it doesn't run with LP-Bridge if I want to have more than one application (N1MM, CW Skimmer, K3_EZ, etc) interfacing with my K3. It is fine for simplifying the changing of AGC settings, but not on the fly during a contest.
Dave AB7E On 12/9/2010 8:18 PM, Sam Morgan wrote: > check out K3_EZ > http://home.roadrunner.com/~n2bc/SW.htm > then connect and check out the AGC Setup page > > GB& 73 > K5OAI > Sam Morgan > > On 12/9/2010 8:49 PM, David Gilbert wrote: >> OK, but that still doesn't address decay or slope ... parameters I might >> want to quickly change dependent upon the amount and type of band noise >> (such as when changing to the low bands or when thunderstorms are >> active) or the number (not only the level) of signals (pileup or QRM). >> >> I still say a few re-callable combinations of AGC settings would make >> sense, even if they had to be initially configured only through the >> CONFIG menu. >> >> 73, >> Dave AB7E > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html