Hi Bob, I disagree. Did you read the Elecraft instructions?? Please do so then comment to Elecraft on the errors in their ways.
Thanks and 73, tom n4zpt On 4/19/2012 12:04 PM, Bob wrote: > I do not believe cutting the part in half is a good idea. The stress > is applied to the pads and they can lift off the board. The potential > for board damage, is very high. > > 73, Bob K2TK > > On 4/19/2012 10:46 AM, Tom Azlin N4ZPT wrote: >> Hi Lee, >> >> I replaced that SMT resistor with the supplied SMT resistor. Was >> pretty easy. Cut the old one in half in place, then unsoldered the >> two pieces. >> >> >> 73, tom n4zpt >> >> > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html