Specifications Amplifier typical gain: 13db RF input: 1 to 20 watts Operating Voltage: 13.8 volts +/- 15% (20 amp power source required) Frequency Range: 160 through 6 meters (ham bands only) RF output Power: 100 Watts, +/- 1 db (with typical 5 watts drive) Operating Modes: AM, FM, AFSK, PSK, SSB, CW Duty Cycle: 50% (TX/RX) 100 watts output. 100% for CW and SSB Front Panel Display: Custom FSTN monochrome LCD Display Back Lighting: 6 LEDs,for more than 200 color options Cooling: 2 internal fans, temperature controlled Harmonic & Spurious Outputs: -50dBc Typical @ 100 Watts HF, -60dBc Typical 6 Meters Third Order Intermod: 30 dB below peak Dimensions (HxWxD): 3.625" x 6.5" x 7.6" (excluding feet and connectors) Weight: 5.4 lbs DC Power Connector: Power Poles Fuse (back panel): 25 Amp, Automotive Blade Style Key Jack: 1/8" Stereo Tip-Key In Ring-Key Out ACC Din Connector: 8 Pin DIN, Key In, Clock/Data/Enable, Ground Construction: Molded Plastic bezel, Aluminum chassis, front & rear panels & textured painted steel covers Antenna Impedance: 50 ohms nominal Automatic fault for: Antenna mismatch(output power >50 watts), Over current, Over temperature, and high input power Works with most antennas (SWR less than 3:1) Easy plug and play operation with Ten-Tec model 539 QRP radio Separate antenna connector provided for automatic switch to six meter antenna Works with most QRP radios RF connectors: 1 RF input, 3 RF outputs (two HF & One 6 meter) Amplifier keyed from direct connection to foot switch, hand switch, or straight key. Key Out from amplifier is provided to key radio.
-----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Matt Zilmer Sent: Sunday, 12 August 2012 1:58 PM To: k2vco....@gmail.com Cc: elecraft@mailman.qth.net Subject: Re: [Elecraft] FW: TEN-TEC announces new amplifier Any specs shown on this? matt W6NIA On Sat, 11 Aug 2012 20:28:57 -0700, you wrote: >This part got my interest > >> TEN-TEC Inc. Announces the Model 418 >> 160-6 Meter Solid State Linear Amplifier in stock and ready for shipment > >But then I read this > >> Generating 100 Watts of output from as little as 5 Watts of input > >And finally, this: > >> The TEN-TEC Model 418 Amplifier is competitively priced at $785.00 > >They must be kidding! ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html