Brian,
Try this -- set the K3 LINE in gain to somewhere near mid-range, and
then adjust the soundcard "speaker" slider to give you close to the 4
ALC bars with the 5th bar flashing. Refine that level with slight
adjustments to the LINE in gain.
You can use TX TEST while making those adjustments which will not
transmit any RF.
Adjust the desired power output with the power knob.
If you do not achieve the required number of ALC bars, the K3 will
"power hunt" causing significant fluctuations in the output power.
There seems to be a greater number of questions about this "problem" for
users of "JT" software than for other soundcard data modes. I don't
know why because the "JT" software should be no different than any other
soundcard data mode. Perhaps the user is trying to follow the
recommendations in the JT mode instructions (I have not looked at them),
but typically data mode instructions are for non-Elecraft tranceivers
and say that the user should set the power to maximum and use the
soundcard audio to adjust the power level. That does not work with
Elecraft gear which controls power differently than other amateur
transceivers. For Elecraft transceivers, adjust the audio level as
specified and adjust the desired power with the power knob. I cannot
stress this fact enough.
73,
Don W3FPR
On 4/16/2017 9:19 PM, Brian Hunt wrote:
Don't see a problem with making minor adjustments of the Line In gain during the first
transmission. When I adjust the level using the WSJT TUNE button I usually see the wild
fluctuations mentioned. A small "tweak" to the gain will set right.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com