What is the recommended temp to run the KPA500 at?
73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist
ARRL Asst. Director, NW Division, Technical Resources
On 4/4/20 3:01 PM, Andy Durbin wrote:
"Does "100% - 10 min, 100 W key-down" mean that if you key down without stop in CW
mode it can go 10 minutes at 100 watts? That seems like an awful lot."
If you want to know what it actually means you'd probably have to run a test
and record the PA temperature. Does it reach maximum value within that 10
minute period? If so, what is that maximum value and do you want to operate
the finals at that temperature? If temperature does not reach a maximum then
what is the rate of increase? At what time does the increasing temperature
cross over the temperature at which you are willing to operate the finals?
I record KPA500 temperatures for every transmission. Unfortunately Kenwood
does not provide finals temperature on the serial bus so I have to make do with
recording my TS-590S rear chassis temperature.
Kenwood provided data shows TS-590S final temperature limited at about 85 deg C
after 5 minutes and remained constant for remainder of the 2 hour 100 W key
down test. (and no, I don't let mine get that hot)
73,
Andy, k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to d...@nk7z.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
