What normally happens is that you blow the auxbus, and end up with a dead radio. Since yours still works, you probably got away with it. Perhaps there was nothing connected to that pin on your cable.
Julian, G4ILO G4ILO's Shack: www.g4ilo.com "Dr. Werner Furlan" wrote: hi, what can happen if a full serial cable from the PC is connected to the K2 serial IO port? I have a special cable for the K2 with RX TX GND lines only, but I mixed it up with the normal serial cable. I have the 10W K2. CAT-control works fine - could I have done some damage to the K2 which is not noticable now? If yes, how can I test it? _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com