That's what I did. 73 Stewart G3RXQ On Mon, 8 Sep 2008 08:00:42 -0400, Roy Morris wrote: > On page 34 of the Installation and Opeation manual it says to remove the W4 jumber > soldered between two pads located between J64A and the KIO3 board. My K3 RF board is > Rev A. W4 is hard wired between two pads located between J64A and the KBPF3 board > mounted above the K3 RF board. It looks as if I am going to have to temporarily remove > the KBPF3 board to remove this jumper. Am I missing something here? Roy Morris W4WFB > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com
_______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com