Roy Morris wrote:
On page 34 of the Installation and Opeation manual it says to remove
the W4 jumber soldered between two pads located between J64A and the
KIO3 board. My K3 RF board is Rev A. W4 is hard wired between two
pads located between J64A and the KBPF3 board mounted above the K3 RF
board. It looks as if I am going to have to temporarily remove the
KBPF3 board to remove this jumper. Am I missing something here? Roy
Morris W4WFB
No, you might have to take it out. I used a dental pick to break the
jumper on my K3 (serial no. 7).
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
