Haines Brown wrote:
I'm struggling to set up K3 for PSK31 and hit a snag.
I can decode signals with fldigi on a Thinkpad X61s running
Sidux. My K3 MCU is 2.46, which apparently I can't upgrade because
that's the highest version for linux at this point. For data mode I've
got the 400 Hz filter selected.
set MIC SEL to LINE IN,
set MODE to DATA,
set RF power to 20W,
set DATA MD to DATA-A.
Now the problem: I hold METER to display CMP/ALC scales. The CMP is
zero, as it should be. I next try to adjust the MIC control to set ALC
to 4 bars, but instead of any bars appearing, the MIC control only
sets LINE to the values 0 to 60.
Silly question(?) ... is there actually audio going into line-in, and is
the TX LED lit when you're doing this? You'll only see ALC bars when
you're actually modulating...
Also I should note that in my laptop waterfall display, the width is
only about 400. I have for FL1 the 8-pole 2.8K and for FL2 the 8-pole
400Hz.
Is this a problem? If you have the 400Hz filter selected, you should
see about 400Hz, no?
Sorry if I'm missing something ...
~Iain
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
