The noise you see on the waterfall should correspond with the DSP BW you have set using the WIDTH knob. The TX filter must be either the 2.8 or 2.7, which ever you have installed.
Put the radio in TX TEST mode and hit the software TX button to send audio to the K3. Now adjust using the MIC gain control (sets the line in level) for 3-4 bars ALC. If you are not getting any ALC reading your soundcard output may be set too low. Try increasing that and try again. I have good success with the soundcard output set to about 20%. ------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 On Tue Oct 28 10:15 , Iain MacDonnell - K6IAM sent: > > >Haines Brown wrote: >> I'm struggling to set up K3 for PSK31 and hit a snag. >> >> I can decode signals with fldigi on a Thinkpad X61s running >> Sidux. My K3 MCU is 2.46, which apparently I can't upgrade because >> that's the highest version for linux at this point. For data mode I've >> got the 400 Hz filter selected. >> >> set MIC SEL to LINE IN, >> set MODE to DATA, >> set RF power to 20W, >> set DATA MD to DATA-A. >> >> Now the problem: I hold METER to display CMP/ALC scales. The CMP is >> zero, as it should be. I next try to adjust the MIC control to set ALC >> to 4 bars, but instead of any bars appearing, the MIC control only >> sets LINE to the values 0 to 60. > >Silly question(?) ... is there actually audio going into line-in, and is >the TX LED lit when you're doing this? You'll only see ALC bars when >you're actually modulating... > > >> Also I should note that in my laptop waterfall display, the width is >> only about 400. I have for FL1 the 8-pole 2.8K and for FL2 the 8-pole >> 400Hz. > >Is this a problem? If you have the 400Hz filter selected, you should >see about 400Hz, no? > >Sorry if I'm missing something ... > > ~Iain > >_______________________________________________ >Elecraft mailing list >Post to: Elecraft@mailman.qth.net >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com