Randy:
In N1MM, go to the configurator, hardware tab, and click on the Set
button for your K3. Make sure that the "Radio PTT via command" is NOT
checked.
73, Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~
Randy Moore wrote:
I enjoyed last weekend operating SSCW with my new K3/10 and N1MM.
Both were a joy to use!! I have one curiosity however. I have the K3
setup for semi-QSK with a delay of 0.03 which works fine for me at
about 25 wpm. However, the keying through N1MM operates as though PTT
is enabled at the beginning of a transmission and disabled at the
end. In other words, I hear no signals during the N1MM transmission.
I'm keying through the RS232 port on the K3 from a standard serial
port on my PC (same cable as used for the CAT from N1MM). I have
PTT--KEY set to OFF-dtr, N1MM set for DTR-CW, RTS-Always off. Is
there something I'm missing?
73,
Randy, KS4L
K3 #2006
K2 #337
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com