Make sure you have not checked "Radio PTT via command" in the N1MM set-up of the K3 COM port if you expect to be able to operate QSK or VOX (semi break-in).
73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Randy Moore > Sent: Friday, November 07, 2008 9:13 AM > To: elecraft@mailman.qth.net > Subject: [Elecraft] K3 with N1MM question > > > I enjoyed last weekend operating SSCW with my new K3/10 and > N1MM. Both > were a joy to use!! I have one curiosity however. I have > the K3 setup > for semi-QSK with a delay of 0.03 which works fine for me at about 25 > wpm. However, the keying through N1MM operates as though PTT > is enabled > at the beginning of a transmission and disabled at the end. In other > words, I hear no signals during the N1MM transmission. I'm keying > through the RS232 port on the K3 from a standard serial port on my PC > (same cable as used for the CAT from N1MM). I have PTT--KEY set to > OFF-dtr, N1MM set for DTR-CW, RTS-Always off. Is there something I'm > missing? > > 73, > Randy, KS4L > K3 #2006 > K2 #337 > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
