Doug, GM0ELP wrote: > Personally I find LO and HIGH cut arkward to use, especially when you have > optional roofing filters installed. This is because the primary function > of > NORM is overloaded to automatically select the 2.7KHz roofing filter???. > The > secondary function of NORM (I/II) means you can have a some defaults, but > try remembering what's behind them in the middle of a contest (if you get > enough time to select them). > > It would be nice if the primary function of NORM just normalised the > current > filter width around the current shift value.
When using narrow (250 Hz 8-pole XTAL) filters in the two receivers I find the shift is sensitive to touch and adjust. It would be good to have smaller increments than the present. I usually have the CW pitch set to 520 Hz. Cannot remember it was this sensitive before the latest F/W upgrade, was it? any one else noticed this? 73 Len SM7BIC _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com