Hello all, I need help picking out a proper dummy load to use for calibrating my new K3. HRO is just up the road and they carry some of the less expensive MFJ dummy loads -- would these be sufficient? Not looking to spend a lot of money, but don't want to buy junk either. What factors should I consider? I'm assuming oil-cooled dummy loads are more robust, while air-cooled loads are more compact, but you have to be more careful when operating or they can burn up more easily. The K3 manual says this is just a 5W test and I need a load with low VSWR from 160 to 6. What is considered "low" SWR? Anything under 1:5?
If I can get by with the MFJ-260 for just $40, that sounds reasonable to me. 73 de Jeff, W6EZY ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html