On 2 October 2014 16:07, Dave Cole <[email protected]> wrote: > So perhaps if I had the tool/jet diameter in a hal float pin, I could > use that along with the analog input function in Gcode to grab the hal > value and then assign it via an invocation of G42.1 or G41.1 ? > > Does that sound possible/reasonable? > > So in this respect the tool table becomes a non issue? Does this sound > correct?
Yes, that ought to work. It could be a physical dial, GUI panel etc. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
