If you end up working/developing on Gentoo, I will make time to lend a hand on that (or as much time as I can).
EBo -- On Dec 30 2015 11:56 AM, Thomas Gambone II wrote: > Neil, > > Are you using an off the shelf A20 board, or did you spin your own? > > As for your distro, what was your approach? > > Did you start from scratch / Linux From Source approach, > ending up with your development copy being nearly identical to the > production copy? > > OR > > Did you start with a light / customizable distro like gentoo, which > has > package management maintained on the dev side. > Then you copy a subset of the system to create your production > distro? > > Continuing Jepler's work with the Odroid boards or similar to make a > robust > embedded controller appliance with LinuxCNC would be excellent to > learn. > > Thank you, > -Tom > > > On Tue, Dec 29, 2015 at 3:27 PM, Rick Lair <[email protected]> > wrote: > >> I will have to look further into this, but Fagor Automation, of >> which we >> have two controls in our shop, is based off of a Linux software, and >> these are "Embedded", straight to the control, no desktop-ish look >> and >> feel. >> >> When you power the control on, it says "DECOMPRESSING LINUX", >> >> >> -- >> >> Thanks >> >> >> Rick Lair >> Superior Roll & Turning LLC >> 399 East Center Street >> Petersburg MI, 49270 >> PH: 734-279-1831 >> FAX: 734-279-1166 >> www.superiorroll.com >> >> >> >> >> ------------------------------------------------------------------------------ >> _______________________________________________ >> Emc-developers mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-developers >> > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
