Jon, A git clone is a git clone. Since you copied your SSH keys over you should be good to go, assuming your SSH pub keys have been added to github. I don't think you have commited for about a year, i.e. since the transition to MS github, so maybe your SSH keys have not been added yet?
Anyway, this will give you a fresh clone of master, set up for SSH. $ git clone [email protected]:LinuxCNC/linuxcnc.git linuxcnc-dev If your SSH key does not match the one on github this may fail with "Permission Denied: public key", or something to that effect. Cheers, Kurt On Sat, Jun 23, 2018 at 12:03 AM, Jon Elson <[email protected]> wrote: > Finally have the decks cleared so I can work on the horrible mess I made > in hal_ppmc.c > So, I have a new computer with PCIe slots, so I can demonstrate the > problem, and I did a fresh install of LinuxCNC, and then cloned the git > repository. Now, I think this is just a plain source checkout, not a > developer checkout. I have copied my .ssh directory from the old computer > I was had a developer checkout on. > > Can somebody give me the steps to make a developer checkout so I can > commit the fix back when I get it right? I know some of the git stuff has > changed. > > (I'm also going to add a few lines of documentation on how to use the > epp_dir command line option while I'm in there.) > > Thanks much in advance, > > Jon > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
