I have installed Debian Wheezy following the instructions in :
http://linuxcnc.org/docs/2.7/html/getting-started/getting-linuxcnc.html
This shows as LinuxCNC 2.7.14
And then tried to get the basic software stepper config
working, from
by_interface/parport/stepper
and I set the parport address for the PCIe parport card in
standard_pinout.hal
I know this is the correct port address as it works with my
diagnostics to the PWM controller.
LinuxCNC comes up, but I get this error message :
linux parallel port @57360 not found
57360 decimal does equal 0xe010, so it is just printing it
as decimal, but why does it
say "not found"?
----------------
However, when I run the sample config for the Pico universal
PWM controller, there is no indication in the logs that any
RT processes have started. no error messages (or I missed
them) but definitely the hal_ppmc driver did not start, as
it always is supposed to produce some dmesg messages.
Any comments welcome! I'm definitely making NEGATIVE
progress here.
Jon
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
