On 07/05/2018 12:32 PM, Dewey Garrett wrote:
In <5b3e4726.5080...@pico-systems.com> Jon Elson <el...@pico-systems.com>
writes:
Any suggestions?
docs section on updating 2.7 to master (2.8~pre):
http://linuxcnc.org/docs/devel/html/getting-started/updating-linuxcnc.html
Thanks, this is what I was looking for!
Well, the automatic script did its thing, and looking
through the .ini and .hal files, it appears to have done a
good job. I can't find anything wrong except the shmem_key
on trivkins, which I took out.
So, now on a fresh startup of LinuxCNC using my boards and
the ppmc driver, the ppmc driver enumerates the device(s) on
the parport, then I get :
waiting for component 'inihal' to become ready
with periods ( . . . . .) constantly being written. After a
couple seconds, the mouse pointer stops responding, and I
have to do a forced power off.
This one sounds real familiar, but I can't remember what to
do about it.
Any suggestions?
Thanks,
Jon
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers