Hi Chris,
Andy asked about the multi-spindle stuff before the last discussion and I
thought it should be fine to get in before the release. I do think we should
probably freeze new features now - but I'm open to any suggestions on that as well!
I'm pretty hammered at work right now, but I'll make a diligent effort to work
on this more very soon.
Or... if someone else would like to volunteer to take over the release
management I would be quite fine with that as well. I have not had the time or
energy to put much into it - and I and volunteered in part because no one else
seemed to want the job. If not - I'll keep going and try and get a release out
soon.
Thanks,
Moses
On 09/29/2018 11:19 PM, Chris Morley wrote:
Moses:
We started this discussion so I will press my luck a bit....
Is my understanding right that you are the release manager of 2.8?
If so could you publicly decide / announce a rough time line of release?
I see Andy has pushed his spindle work to master so was the decision to release
later ? Did I miss that?
I believe, (at least soft) deadline are necessary to keep this project alive
and thriving in the long term.
I would appreciate if this was public (maillist) and not private (IRC) (of
course both is good too)
Thanks
Chris M
________________________________
From: Moses McKnight <[email protected]>
Sent: September 19, 2018 2:27 PM
To: [email protected]
Subject: Re: [Emc-developers] New Stuff
I agree that we should release sooner than later. It would be great if the
issues mentioned by Rene were fixed prior to a release, but realistically some
of those may take a while.
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
