I have found that using ammeters at low voltages, the input resistance will interfere with the current measurement and give you a lower value. I use precision 0.1 ohm resistors in parallel, and measure the voltage across the resistors.
Best regards, David. David Gelfand Approvals/Design Engineer Memotec Inc. Tel: 514 738 4781 x4151 Fax: 514 738 4436 david.gelf...@memotec.com This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: majord...@ieee.org with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: emc-p...@hypercom.com Dave Heald: davehe...@attbi.com For policy questions, send mail to: Richard Nute: ri...@ieee.org Jim Bacher: j.bac...@ieee.org Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc