If you don't mind etching a board yourself there are some good DIY options here: http://www.pminmo.com/
----- Original Message ----- From: "Jack" <[EMAIL PROTECTED]> To: "'Enhanced Machine Controller (EMC)'" <emc-users@lists.sourceforge.net> Sent: Saturday, May 26, 2007 10:01 AM Subject: [Emc-users] Low end stepper driver controller? > Ok, I'm cheap. ... I have some small surplus 4 wire steppers. ((Nipon > Pulsemotor, 2A/phase 1.7 Ohms/phse. Type PJ55P1U36B)). > > Where can I find a cheap controller (kit or prebuilt) that will drive > these? > Yes, I want to use EMC. I have a HobbyCNC controller, but it doesn't > drive > this kind of motor, and when asked on that forum, I am nicely told to go > away. > > TIA, Jack ------------------------------------------------------------------------- This SF.net email is sponsored by DB2 Express Download DB2 Express C - the FREE version of DB2 express and take control of your XML. No limits. Just data. Click to get it now. http://sourceforge.net/powerbar/db2/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users