Sebastian, et al, I am getting a strange error using the hostmot2 driver and the 7i43 board. The error is "hm2/hm2_7i43.0: TRAM write error! (addr=0x1000, size=8, iter=68373). The error occurs when running a g-code program but not while jogging, at least initially.
If I bring the system up from a fresh boot, I can jog. But once I run a g-code program and get the error, I will then get a following error if I try to jog an axis. Additionally, if I shut down the program and restart, immediately after coming up again I get an error "hm2_7i43:/DONE is not low after CPLD reset! Except for remapping some of the GPIO (which is currently mostly disabled) and of course the bit file specified, the configuration is identical to my working configuration on the m5i20 controller. I get the same error and symptoms for both SVST4_4B.BIT and SVST4_6B.BIT. I gather it has something to do with the communications over the parallel port, but not sure what if any parameters affect that. Any ideas? Thanks, Eric ------------------------------------------------------------------------------ SF.Net email is Sponsored by MIX09, March 18-20, 2009 in Las Vegas, Nevada. The future of the web can't happen without you. Join us at MIX09 to help pave the way to the Next Web now. Learn more and register at http://ad.doubleclick.net/clk;208669438;13503038;i?http://2009.visitmix.com/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
