El 20/12/2008 01:46 a.m., Sebastian Kuzminsky escribió:
> Peter C. Wallace wrote:
>
>> On Tue, 16 Dec 2008, Richard Acosta wrote:
>>
>>
>>>> Did sc7i43P report that the 7I43 had a 400K FPGA?
>>>>
>>>>
>>> Yes it says a 400k
>>>
>>>> Well it should say something like:
>>>>
>>>> Pass: 1 Error Count: 0 loop count: 100000
>>>> Pass: 2 Error Count: 0 loop count: 200000
>>>> Pass: 3 Error Count: 0 loop count: 300000
>>>>
>>> and i confirm this too.
>>>
>> Have you tried upgrading to 2.2.8?
>>
>> I just did this on a test machine here (motherboard parallel port @ 0x378,
>> 7I43-4 connected), started emc, (absolutely stock, no changes) doubleclicked
>> on the hm2servo sample config (from Ted Hyde) and I was up and running (well
>> I
>> dont have machine attached but I did end up with a Axis being a nice 3d
>> Etch-A-Sketch when I turned the motor shafts.
>>
>
> If 2.2.7 doesnt work for him, i dont know why 2.2.8 would. Something's
> wrong with Richard's hardware.
>
OK, this is what i meant on my last message. My hardware is suppossed to
be OK, i have made a few tests on DOS and all went fine.
I guess there is something wrong on linux, config files or the driver
itself.
The error now is "unknown command" when using 2.2.6 lights went OK after
loading firmware and they give me OK (ready), but now they dont.
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
