On Tue, 16 Dec 2008, Richard Acosta wrote:
>
>> Did sc7i43P report that the 7I43 had a 400K FPGA?
>>
> Yes it says a 400k
>>
>> Well it should say something like:
>>
>> Pass: 1 Error Count: 0 loop count: 100000
>> Pass: 2 Error Count: 0 loop count: 200000
>> Pass: 3 Error Count: 0 loop count: 300000
> and i confirm this too.
Have you tried upgrading to 2.2.8?
I just did this on a test machine here (motherboard parallel port @ 0x378,
7I43-4 connected), started emc, (absolutely stock, no changes) doubleclicked
on the hm2servo sample config (from Ted Hyde) and I was up and running (well I
dont have machine attached but I did end up with a Axis being a nice 3d
Etch-A-Sketch when I turned the motor shafts.
Thanks Sebastian!
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
