I think this is related to the hotplug mechanism. When your PC boots it detects the mesa board, and hotplugs it (loads the driver for it). Can you reboot your PC, and after the fresh boot send us the output from lsmod ?
Regards, Alex ----- Original Message ----- From: "Donnie Timmons" <dtimm...@etex.net> To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Sent: Sunday, January 04, 2009 6:49 AM Subject: Re: [Emc-users] EMC startup error > :-) > > I found the problem with the encoder. It helps to be switching the wire to > the right encoder. I over look the fact that axis 0 and 2 are on TB1 and 1 > and 3 are on TB2. > > Still having the startup problem after a power down in that I have to > start > EMC two times with the first erroring out. After that it will start ever > time till power down again. > > Donnie > ----- Original Message ----- > From: "Peter C. Wallace" <p...@mesanet.com> > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > Sent: Saturday, January 03, 2009 11:51 PM > Subject: Re: [Emc-users] EMC startup error > > >> On Sat, 3 Jan 2009, Donnie Timmons wrote: >> >> > Date: Sat, 3 Jan 2009 22:25:38 -0500 >> > From: Donnie Timmons <dtimm...@etex.net> >> > Reply-To: "Enhanced Machine Controller (EMC)" >> > <emc-users@lists.sourceforge.net> >> > To: "Enhanced Machine Controller (EMC)" > <emc-users@lists.sourceforge.net> >> > Subject: Re: [Emc-users] EMC startup error >> > >> > Peter >> > >> > I have TTL encoders so the /A and /B are not used or do I have connect > them >> > to ground? Is there any setting other than the jumps on the 7i33 to set > for >> > TTL >> >> >> Oh ok, for TTL leave the /A and /B inputs unconnected. I would check the >> signal levels with a 'scope or DVM though... >> >> Peter Wallace >> >> -------------------------------------------------------------------------- > ---- >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.176 / Virus Database: 270.10.2/1873 - Release Date: 03.01.2009 14:14 ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
