Tom, an even better explanation is in the 2.3 docs here:

http://www.linuxcnc.org/docs/devel/html/hal_basic_hal.html#r1_1_4

John

On 10 Jan 2009 at 6:20, Tom wrote:

> Stephen & John,
> 
> I should have mentioned that it was me who was going to get the
> wording right all along ;-)
> 
> John, thanks for your attention to helping me (or us) understand the
> new "net"
> command. I only recently started using it, and it works just as
> outlined here:
> http://www.linuxcnc.org/docview/html//hal_basic_hal.html#r1_1_4
> 
> Of course you are right about leaving verbose comments in the body
> of the hal
> and ini files. I can do better here...
> 
> Thanks a bunch for your help guys. 
> 
> Tom
> 
> 
> 
> 
> 
> --------------------------------------------------------------------
> ----------
> Check out the new SourceForge.net Marketplace.
> It is the best place to buy or sell services for
> just about anything Open Source.
> http://p.sf.net/sfu/Xq1LFB
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
> 



------------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It is the best place to buy or sell services for
just about anything Open Source.
http://p.sf.net/sfu/Xq1LFB
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to