Sounds good, then I'm at least closer to a working config. I did all the PID tuning, unfortunately I don't have the Step time-values but I hope someone at Rutex can give me them. I'm close to giving up on these controllers as I can't find info about them any longer except for the PID tuning.
2009/9/23 Rob Jansen <r...@myvoice.nl> > Sven, > > I'm using Rutex 990H cards and Minerva (Yaskawa robot) servo's rated 67 > V/10 > > A, and I have so much power in the electric feed I can use the control > box > > as a welding machine . > > > These Rutex drivers are step-servo drives, meaning that they convert a > stepper output (from your CNC controller) into motor signals for a servo > motor. > I can't find much about the 990H, apparently Rutex is not selling those > anymore and there is no documentation on their website. I hope you have > all the docs and software to setup your system. > > I did a new configuration with Stepconf, will that really work with > servo's? > > It says in the documentation that it should handle any step/dir config > but I > > only see stepper motor settings and not really something that is servo > > related. > Correct, that is the beauty of these system. It almost suggest you don't > need to know about servo controllers and PID parameter settings. And > that is true - for your EMC config. > From the CNC controller software you only need to know about feed > rates, and stepper timing - but you will need to program the PID > parameters in the servo controller if that is not done by the machine > provider. > Please note that these type of servo drivers use mostly microcontrollers > to convert the stepper signals. They may/will have special requirements > on step timing and the moment when you change the direction signal. Do > read the manual of the 990H very thoroughly and check your stepper > settings. > > > I'll try to test the encoders like stated here > > http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Tuning_EMC2/HAL_PID_Loopslater > > > EMC sees your system as a stepper system (possibly with encoder > feedback), all PID loop settings are done inside the 990H drivers (and > should be tuned in there). > > Regards, > > Rob > > > ------------------------------------------------------------------------------ > Come build with us! The BlackBerry® Developer Conference in SF, CA > is the only developer event you need to attend this year. Jumpstart your > developing skills, take BlackBerry mobile applications to market and stay > ahead of the curve. Join us from November 9-12, 2009. Register now! > http://p.sf.net/sfu/devconf > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Come build with us! The BlackBerry® Developer Conference in SF, CA is the only developer event you need to attend this year. Jumpstart your developing skills, take BlackBerry mobile applications to market and stay ahead of the curve. Join us from November 9-12, 2009. Register now! http://p.sf.net/sfu/devconf _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
