On Tue, Aug 17, 2010 at 1:15 PM, Andy Pugh <[email protected]>wrote:
> On 17 August 2010 17:26, Don Stanley <[email protected]> wrote: > > > I am planning to convert a Bridgeport knee mills to EMC. > > So far, I am unable to find an example of how to > > configure stepper outputs using Linear Encoders for position. > > The advice I have seen has been to take a generic servo config and > modify it such that the outputs that normally go to the PWM .value > inputs instead go to the .value of a stepgen that is configured in > "velocity mode" > atp > Sincerest Thanks Andy; I appreciate your addressing my specific question. That was my only guess as to how it could be done. But I think, newbies shouldn't presume; especially me. Did you recognise it is a CNC converted mill that I wanted to move to EMC2? Thanks again Don ------------------------------------------------------------------------------ > This SF.net email is sponsored by > > Make an app they can't live without > Enter the BlackBerry Developer Challenge > http://p.sf.net/sfu/RIM-dev2dev > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ This SF.net email is sponsored by Make an app they can't live without Enter the BlackBerry Developer Challenge http://p.sf.net/sfu/RIM-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
