Guys, First off, thanks to all for porting EMC to 10.04, it is fantastic.
Just a question. I use quick change toolholders based on NMTB-30. I am trying to get a tool table started. And I wonder if I can simply measure the total length of the tool, in toolholder, with a caliper, and then subtract say 4 inches and use that as offset. OFFSET = TOTAL LENGTH - 4 inches Is that completely wrong? At least this way, it is easy to set up a tool table and it does not require complicated tool setters, etc. - Igor ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users